Eeprom; Printer Model - Ricoh G165 Service Manual

Electrical Components

3.11.13 EEPROM

Replacement and Reinstallation procedures for the EEPROM are included in the
"EGB (Engine Board)" replacement procedure. Refer to "EGB (Engine Board)" for
details.
When replacing an old EEPROM with a new EEPROM, EEPROM setting is required.
Follow the EEPROM setting procedure described below.

Printer Model

Do the following steps 1 to 11 with the front cover of the machine open. After
completing these steps, turn off the machine.
1. Open the front cover and turn on the machine.
The machine may issue an error code (because the cover is open), but
continue this procedure.
2. Access the "SP Mode 2" tab.
3. Click the "Init Engine EEPROM" button to initialize the EEPROM.
4. Input the serial number in the "Serial No." box.
Ask your supervisor about how to input the serial number in its box.
5. Select a destination from the "Destination" box.
6. Select a model from the "Model" box.
7. Click the "SP Mode 1" tab.
G165/G166/G167/G181/G183/G184
CÓPIA NÃO CONTROLADA
3-60
CÓPIA NÃO CONTROLADA
SM