To Replace Ice Maker Control Arm Shut-Off Switch; To Replace Ice Maker Thermostat; To Replace Thermal Cut-Out (Tco) - Electrolux Side by Side Refrigerator Service Manual

To Replace Ice Maker Control Arm Shut-OFF Switch

1. Remove Ice Maker from Freezer.
2. Remove front Cover.
3. Remove three screws that attach Mounting Plate to Support Housing.
4. Disconnect three Ice Maker Control Arm Shut-Off Switch wire leads.
5. Raise Ice Maker Control Arm Lever.
6. Remove two Ice Maker Control Arm Shut-Off Switch mounting screws.
7. Remove switch.
8. Replace switch in reverse order.

To Replace Ice Maker Thermostat

1. Remove Ice Maker from Freezer.
2. Remove front Cover.
3. Remove three screws that attach Mounting Plate to Support Housing.
4. Loosen two Thermostat retaining clip mounting screws.
5. Disconnect two thermostat wire leads and remove thermostat.
6. Apply thermal mastic sealer to sensing surface of replacement thermostat
to ensure a positive bond to mold.
7. Replace thermostat in reverse order.

To Replace Thermal Cut-Out (TCO)

1. Remove Ice Maker from Freezer.
2. Remove front Cover.
3. Remove three screws that attach Mounting Plate to Support Housing.
4. Pull cable assembly free from support housing. It will slide out easily.
5. Loosen screw securing clamp to TCO. TCO should come free after tension
from clamp is released.
6. Disconnect TCO from two wire nuts. One end is connect to the cable
assembly and the other end is connected to the motor and mold heater.
7. Replace with new TCO.
8. Reassemble in reverse order.
Section F - Ice Maker
91