Electrical Information; Leveling - Electrolux Side by Side Refrigerator Service Manual

ELECTRICAL INFORMATION

The refrigerator must be plugged into its own 115 Volt, 60 Hz, AC only electrical
outlet. The circuit should be protected by a 15 or 20 Amp circuit breaker or time
delay type fuse.
N OTE
If voltage varies by ±10% of 115 volts, performance of the refrigerator may be affected.
Operating the refrigerator with insufficient power can damage the compressor.
The refrigerator power cord is equipped with a three prong grounding plug. It must
be plugged directly into a properly grounded three prong receptacle. The receptacle
must be installed in accordance with local codes and ordinances. Do not use an
extension cord or an adapter plug.

LEVELING

The refrigerator must be leveled with all bottom corners resting firmly on a solid
floor. Adjust the front rollers to level the cabinet from side-to-side and front-to-rear.
Keep the cabinet as low as possible for stability. Never adjust the cabinet rollers so
the front is lower than the rear.
N OTE
Rear rollers are not adjustable.
To adjust the front rollers:
1. Open refrigerator and freezer doors.
2. Remove toe grill by removing two screws and pulling it
straight out. (See Figure A2.)
3. Adjust rollers by turning each roller adjusting bolt with flat-blade
screwdriver, adjustable wrench, 3/8" socket wrench, or 3/8"
nutdriver until refrigerator is level and stable. (See Figure A3.)
Section A - Installation
3
Figure A2
Raise
Figure A3