Electrolux Side by Side Refrigerator Service Manual page 65

Section E- Refrigeration System
10. Reform both suction and
discharge lines to align
with new compressor. If
they are too short, use
additional lengths of
tubing. Joints should
overlap 0.5" to
provide sufficient area for
good solder joint. Clean
and mark area where
tubing should be cut .
Cut tubing with tubing
cutter. Work as quickly
as pos- sible to
avoid letting moisture
and air into system.
N OTE
If low-side process tube is too short, silver solder four inch piece of tubing onto
process tube before installing compressor.
11. Solder all connections according to soldering procedure outlined on page 49.
12. Remove original filter-drier.
CAUTION
DO NOT unbraze old filter-drier from system. This will vaporize and drive moisture from
desiccant back into system. The old filter-drier should be cut out of system.
13. Install new filter-drier at condenser outlet.
N OTE
If system is and/or old compressor oil is badly contaminated, use the new 2 stage drier-
filter, part # 5303918288. Refer to Service Bulletin Volume 23, # 3, page 13.
14. Evacuate and charge system using recommended procedure described
under Evacuating and Recharging.
15. Reconnect compressor terminal leads in accordance with refrigerator wiring
diagram.
16. Reassemble unit.
Bracket
Grommet
Condenser
Motor
Motor
Support
Silencer
Fan Blade
Speed Nut
Bracket Grommets
Shroud
Condenser
Grommets
Figure E1
Motor Bracket
Shoulder Screw
Screws
Motor
Bracket
Spacers
Wiring
Harness
Clamp
Roller
Roller
Mounting
Pins
5 7
Washer
Filter Drier
Compressor
Capacitor
Clamp
Compressor
PTC Starter
Mounting
Grommets
Roller