Change Between Fahrenheit & Centigrade; Advance Into Defrost Cycle Manually; Activation; Deactvation - Electrolux Side by Side Refrigerator Service Manual

2 8
Section C - Electronic ControlsDoor
Change Between Fahrenheit and Centigrade
To change form Fahrenheit to Centigrade, press the Mode key.
To change form Centigrade to Fahrenheit, press the Mode key.

Advance Into Defrost Cycle Manually

Activation

Press and hold Freezer Temperature UP (WARMER) Key while pressing the fresh
food temperature DOWN (COLDER) key 5 times within 6 seconds. This will
advance the processor into defrost cycle.
Deactivation
Press and hold Freezer Temperature UP (WARMER) Key while pressing the fresh
food temperature DOWN (COLDER) key 5 times within 6 seconds. This will
advance the processor out of defrost cycle. Or just let the refrigerator alone and it
will go through a normal defrost cycle and start running after defrost limit switch
has turned off the heater and the controller has allowed for a normal drip time.

OPERATION - UPDATED REVISION L

User Interface – Ver. A

Freezer

Displays are off when Fresh Food Door is closed. Communications remain active.
Default = 0°F (-18°C).
(Two Position Read Out for Freezer and Food Compartment)
Temperature UP key increments temperature setting up
one degree, F or C, for each key press. Setting Upper
Limit = +6°F (-14°C).
Temperature DOWN key decrements temperature
down setting one degree, F or C, for each key press.
Setting Lower Limit = -6° F (-21°C). Each key press
(Temperature UP or DOWN) displays temperature
setting. Actual temperature will be displayed after 10
seconds of no key entries and during normal operation.
(on some models)