Table of Contents
Advertisement
18
www.electrolux.com
2. Before you remove the ice carriage,
remember to disengage it from the glass
shelf as it may result in damage to the
assembly.
3. Remove the centre runner by disengaging
it at the front of the shelf, and removing it
from the rear.
Insert Into the slot at the rear
of the shelf
4. Refit the runner into the rear of the shelf on
the right hand side and then engage the
front.
7. CLEANING YOUR REFRIGERATOR
Then engage Into the front
of the shelf
WARNING
BEFORE CLEANING: Turn the refrigerator
off at the power point and unplug the
cord to prevent any chance of
electrocuting yourself.
Doors and exterior (white and silver):
You should only clean the doors with lukewarm
soapy water and a soft cloth.
Stainless Steel:
Your stainless steel refrigerator is manufactured
from mark-resistant stainless steel. This stainless
steel has a special advanced protective
coating that eases the removal of marks such
as fingerprints and water spots. To keep its
appearance, clean it regularly with lukewarm
soapy water and a soft cloth.
WARNING
Never use stainless steel cleaners,
abrasive pads or other cleaners that will
scratch the surface. Damage to the
appliance after delivery is not covered
by your warranty.
Interior
Clean the inside of your refrigerator regularly
with a soft cloth, unscented mild soap and
lukewarm water. Thoroughly dry all surfaces
and removable parts and avoid getting water
on the controls. Replace removable parts, plug
power cord in and switch the power on before
returning the food.
Insert Into the slot at the rear
of the shelf
Then engage Into the front
of the shelf
5. Fit the carriage by sliding it into the runners
until the front if the carriage engages with
the shelf.
6. Refit the ice tray and ice bin.
WARNING
Fill the ice tube tray with potable water
only.
CAUTION
LED lighting
Your appliance is fitted with long life
LED lighting. In the unlikely event the
LED lights should fail, then the LED lights
should be serviced by the manufacturer.
Refer to the warranty page for contact
details.
Door seals
Always keep door seals clean by washing them
with a mild detergent and warm water, followed
by a thorough drying. Sticky food and drink
can cause seals to stick to the cabinet and tear
when you open the door.
Never use hot water, solvents, commercial
kitchen cleaners, aerosol cleaners, metal
polishes, caustic or abrasive cleaners, or
scourers to clean your refrigerator. Many
commercially available cleaning products and
detergents contain solvents that will damage
your refrigerator. Use only a soft cloth with an
unscented mild soap and lukewarm water.
WARNING
To clean a crisper or freezer bin with
telescopic extension slides, simply wipe
with a damp cloth and warm soapy
water. Never immerse the cover in water,
as this could affect the operation of the
slide.
Switching off your refrigerator
If you switch off your refrigerator for an
extended period, follow these steps to reduce
the chances of mould:
1. Remove all food.
2. Remove the power plug from the power
point.
3. Thoroughly clean and dry the Interior.
4. Ensure that all the doors are wedged
open slightly for air circulation.
Advertisement
Table of Contents
