Electrolux Side by Side Refrigerator Service Manual page 121

114
Section G - Ice & Water Dispenser
Figure 17
Figure 18
Main housing for
dispenser is part
of the outer door
panel.
Figure 19
The closer can be replaced by removing 3 screws and lifting closer from housing.
The door is held in place with a shaft at the top. The spring that holds the door
closed and sealed against the housing is over the shaft and can be replaced by
using a small punch and removing the shaft. (See Figure21)
The door closer is mounted on the side of the housing (See Figure 21) and
connected to the door arm with a gear wheel to slow the closing of the door. (See
Figure 22) This allows enough time for the ice to clear the chute.
The door will take approximately 20 seconds to close after the glass is removed
from the actuator.
With the board removed, remove the 3 screws from
the dispenser housing and pull the dispenser forward.
Remove
(See Figure 17)
screws
Remove water line from dispenser housing by pulling
straight out. (See Figure 18)
Pull housing
With the water line removed, the upper part of the
forward
dispenser is free of the freezer door panel. The main
housing is part of the door panel, and is not removable.
(See Figure 19)
The ice door and actuator switches, as well as the return
Remove
springs, can be serviced with the control module
water line
removed. (See Figure 20)
Ice Door
Return Springs
Actuator
Switches
Door Closer
Figure 20
Figure 20