Electrolux Side by Side Refrigerator Service Manual page 120

Section G - Ice & Water Dispenser
On models with electrical mechanical selector on the front
panel, when you remove the front you can gain access to the
secector switch (See Figure 12)
The switch is of the push button type (See Figure 13) It will have
a red indicator on a slide that will slide up and down to indicate
the switch position. The switch will plug directly into the
dispenser harness.
ICE
Cube Crushed
ON
PUSH BUT
Figure 13
To test the switch you will check between the Red-
Black and the Black wire for the dispenser light.
Between the Blue-White and the Purple the cube ice
solenoid. The switch contacts should show open
the off position and closed in the on position for the light.
The switch contacts for cube ice should show closed
and should show open for crushed position. (See Figure
14)
On models with electronic control to gain access to the
control, snap the light socket loose and remove the 6
small screws from the board. (See Figure 15)
Unplug board Disconnect actuator
switches
Figure 16
LIGHT
OFF
Sliding
Indicator
Pull board straight out of housing.
Disconnect plug on left side of board.
Disconnect 4 wires to dispenser actuator
switches. (See Figure 16)
Model with electrical
mechanical control
Test Point for
Dispenser
Light
Figure 14
Remove
screws
Figure 15
113
Figure 12
Test
Point