Electrolux Side by Side Refrigerator Service Manual page 122

115
Section G - Ice & Water Dispenser
Use a small punch to
Gear driver used to connect
remove shaft.
door closer to arm on door.
Ice Door Closer
Figure 22
Figure 23 Figure 21
Tension is held against both the water and ice actuator by a
stainless steel, two bladed spring mounted behind the actuator
switches. The spring is held in place with 2 screws. (See Figure
24)
The Actuators are held in place by stainless clamps at each end of
the actuator and the two bladed spring in the middle. (See Figure
25) The actuators can be removed by removing the 4 screws and
lifting the paddle / ice chute out of the housing.
On models electrical mechanical switch the dispenser will come
apart the same way as models with a control board. The difference
Tension Spring for Actuators
is the wiring to the actuator switches and the selector switch are
FIGURE 24
connected directly the plug in the door wiring harness. (See Figure
26)
Spring and clamps used
to hold actuators in place.
Connector from door harness
to actuator switches
Figure 25
Figure 26