Electrolux Side by Side Refrigerator Service Manual page 124

Section G - Ice & Water Dispenser
The connector on the left side of the board is for the door
wiring harness to plug into. (See Figure 30) This wiring harness
connects with the Main Harness through the top freezer door
hinge. (See Figure 31) The main harness will connect to the
machine compartment harness and to the service cord. The
board will then send power to other parts that operate through
the board.
The labeling is as follows:
1. NEUTRAL (one side of line to power the board)
2. CUBE (connected to solenoid for ice cubes)
3. AUGER (connected to auger motor)
4. FICE (fast ice/fast freeze feature)
5. WATER (connected to water valve yellow coil)
6. 120 V AC (other side of line to power the board)
(See Figure 32)
The relays mounted on the board are
numbered. (See Figure 33)
K1 - Controls the Light in the
Dispenser.
K2 - Controls the Water to the
Door
K3 - Controls the Solenoid for
Cube Ice
K4 - Controls the Auger motor
The power supply onto the board is 120 VAC. The
transformer is mounted on the board and is used to reduce
the operating voltage. (See Figure 32) There are 4 diodes
mounted on the board to convert the AC current to DC
current. (Touch Board - See Figure 34). The operating
voltage for the control board is 8 to 13 V DC.
Control Board Icon Model
All Other Models
Figure 34
Connector on Control Board
N E U T R A L
FICE
W A T E R
C U B E
120 V AC
A U G E R
Figure 32
Connector
Door Harness
Relays K4, K3, K2, K1 Transformer
Figure 30
Door wiring harness will connect
to the main harness at the plug
under the top hinge cover.
Figure 33
RELAYS K4, K3, K2, K1
117
Wires connecting
ice & water switches
Figure 31
Diodes
Transformer