To Remove Lamp Socket And Light Bulb; Ice Auger & Crusher Assembly; To Remove Ice Auger & Crusher Assembly - Electrolux Side by Side Refrigerator Service Manual

Section G - Ice & Water Dispenser
To Remove Lamp Socket and Light
Bulb:
1. Disconnect refrigerator from electrical
supply.
2. Remove Ice Cream Shelf and slide Ice
Container forward and off Rail Assembly.
3. Loosen 2 screws holding Ice Maker to rail
assembly. Unplug Molex connector and lift
Ice Maker off of loosened screws and pull
free.
4. Remove 2 screws on bottom of Rail Assembly holding it to mounting
brackets. Unplug Molex connector. Lift up on Rail Assembly and pull forward,
freeing it from mounting brackets.
5. Disconnect yellow and white wires connected to lamp socket located behind
Motor Cover.
6. Press in on two tabs on bottom of lamp socket base and push through
mounting hole. (See Figure G4.)
7. Replace lamp socket in reverse order.
ICE AUGER & CRUSHER ASSEMBLY
To remove Ice Auger & Crusher Assembly:
1. Remove four (4) screws holding Ice Container Front to
Ice Container.
2. Remove two (2) screws on underside of Ice Container,
holding Crusher Housing to container.
3. Remove screw holding Control Rod to container, located
on underside of container.
4. Remove three (3) Hex head screws holding Crusher
Housing to Front Plate. (See Figure G5)
5. Remove E-ring and washer on front of Crusher Housing.
(See Figure G5.)
CAUTION
The Crusher Blades are very sharp. Use protective gloves when handling Crusher
Blades.
Tabs
Light
Socket
Light Bulb
Figure G4
Crusher Housing
Screw
109
Motor Cover
Gate
Figure G5
Washer
E-ring