Trouble Shooting; How To Change The Bulb; If Something Does Not Work - Electrolux SB 318 N User Manual

46 electrolux
Changing the Carbon Filter
To maintain the best performance the
carbon filter should be changed every
year.
New carbon filters can be purchased
from your local dealer.
1. Pull the flap outwards. (1)
2. Remove the filter from the plastic bag.
3. Insert the filter in the slot found in the
back of the flap cover (2).
4. Close the flap cover.
Note: the carbon filter is a consumable
accessory and as such is not covered by
the guarantee.
i During operation, always keep the air
ventilation flap closed.
i The filter should be handled carefully so
fragments do not loosen from the
surface.

Trouble shooting

How to change the bulb

Should the light fail to work you can
change it as below:
Break the circuit of the appliance.
Press the rear hook (1) of the lampcover
by a screwdriver and at the same time
pull and rotate the cover in the direction
indicated by the arrow (2). So the bulb
can be replaced. (Bulb type: T25
Daylight 230-240 V, 25 W, E 14 thread)
GB
After changing the bulb replace the
cover, snap it in place and apply voltage
to the appliance.

If something does not work

During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart
information is given about them to avoid
unnecessary charges on service.
We draw your attention that operation of
appliance goes with certain sounds
(compressor- and circulating sound). This
is not trouble, but means normal
operation.
We draw it to your attention again
that the appliance operates
discontinuously, so the stopping
of compressor does not mean being no-
current. That is why you must not touch
the electrical parts of the appliance
before breaking the circuit.