Regular Cleaning; When The Refrigerator Is Not In Use; Trouble Shooting; How To Change The Bulb - Electrolux ERD 24001 W Instruction Book

Hide thumbs Also See for ERD 24001 W:
Table of Contents

Advertisement

Regular cleaning

It is recommended to wash the inside of
the refrigerator in 3-4 weeks time using
lukewarm water then wipe it (it is practical
to clean the inside of the freezer and
defrost it at a time).
Household cleaner or soap must not be
used.
After breaking the circuit wash the
appliance with lukewarm water then wipe
it. Clean the door gasket with clean
water. After cleaning apply voltage to the
appliance.
It is recommended to remove the dust
and dirt collected on the back of the
refrigerator and the condenser and to
clean the evaporative tray on top of the
compressor once or twice a year.

When the refrigerator is not in use

In case the appliance will not be used for
a long time follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up
.
of air inside

Trouble shooting

How to change the bulb

Should the light fail to work you can
change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp
cover, then take the lamp cover off in the
direction of arrow and the bulb can be
changed. (Type of the bulb: Mignon 322,
230 V, 15 W, E 14 thread)
After changing bulb replace the lamp
cover, screw the plate screw and apply
voltage to the appliance.
The lack of light does not influence
operation of the refrigerator.

If something does not work

During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart
information is given about them to avoid
unnecessary charges on service.
We draw your attention that operation of
appliance goes with certain sounds
(compressor- and circulating sound). This
is not trouble, but means normal
operation.
We draw it to your attention again
that the appliance operates
discontinuously, so the stopping
of compressor does not mean being no-
current. That is why you must not touch
the electrical parts of the appliance
before breaking the circuit.
electrolux 37
GB

Advertisement

Table of Contents
loading

Table of Contents