Chapter 3. Operation Of Web-Based Management - TP-Link TL-SG3424 User Manual

Fig. 2-14 Peer-to-peer Network Connection
Fig. 2-15 Office Network Connection
Publication date: January, 2006
27
User Manual
Revision A2
User Manual
3. Operation of
Web-based Management
This chapter instructs you how to configure and manage the switch through
the web user interface it supports, to access and manage the 22-Port
10/100/1000Mbps TP and 2-Port Gigabit TP/SFP Fiber management Ethernet
switch. With this facility, you can easily access and monitor through any one port of
the switch all the status of the switch, including MIBs status, each port activity,
Spanning tree status, port aggregation status, multicast traffic, VLAN and priority
status, even illegal access record and so on.
The default values of the managed switch are listed in the table below:
IP Address 192.168.223.100
Subnet Mask 255.255.255.0
Default Gateway 192.168.223.254
Username admin
Password admin
Table 3-1
After the managed switch has been finished configuration in the CLI via the
switch's serial interface, you can
http://192.168.223.100 in the address row in a browser, it will show the following
screen (see Fig.3-1) and ask you inputting username and password in order to login
and access authentication. The default username and password are both "admin".
For the first time to use, please enter the default username and password, then click
the <Login> button. The login process now is completed.
Just click the link of "Forget Password" in WebUI (See Fig. 3-1) or input
"Ctrl+Z" in CLI's login screen (See Fig. 4-1~4-2) in case the user forgets the
manager's password. Then, the system will display a serial No. for the user. Write
down this serial No. and contact your vendor, the vendor will give you a temporary
password. Use this new password as ID and Password, and it will allow the user to
login the system with manager authority temporarily. Due to the limit of this new
password, the user only can login the system one time, therefore, please modify
your password immediately after you login in the system successfully.
In this login menu, you have to input the complete username and password
respectively, the switch will not give you a shortcut to username automatically. This
looks inconvenient, but safer.
Publication date: January, 2006
Revision A2
28
browse it. For instance, type