TP-Link TL-SG3424 User Manual page 36

Function name:
Per Port Priority
Function description:
We can assign QoS Priority, including High and Low for each port. For
example, if we transmit IP packets from Port 2 and Port 3 at the speed of
1Gbps to Port 1, and set the Class of Port 2 as High and Port 3 as Low, then
the packets of Port 3 will be dropped when the congestion happens because
Port 2 owns higher precedence of transmitting packets.
Parameter description:
Port No:
User can choose the port (1~24) respectively with Priority Class on Per
Port Priority function.
Class:
User can set up High Priority or Low Priority for each port respectively.
Fig. 3-18
63
User Manual
Publication date: January, 2006
Revision A2
User Manual
Function name:
VLAN Tag Priority
Function description:
In vlan tag, there are 3 bits belonging to priority. According to these 3 bits, we
could arrange 8 traffics –0 0 0, 0 0 1, 0 1 0, 0 1 1, 1 0 0, 1 0 1, 1 1 0, 1 1 1. We
can set High priority or Low priority for each traffic class. For instance, if we let
VLAN-tagged priority 0 0 0 be high priority and VLAN-tagged priority 0 0 1 be
Low Priority, and then make port 1, 2, 3 be in the vlan 2. We sent the packets
that have the value 0 0 0 in vlan-tagged field and VID equals 2 from the port 2
and the packets that have the value 0 0 1 in vlan-tagged field and VID equals
2 from the port 3 into the switch. We let the two kinds of packets be
transmitted for port 1 until the port results in congestion. The result is that the
packets will be dropped partially from the port 3 because the packets that
belong to Low Priority. For the use of VLAN Tag Priority function, please press
<Configure> button at the right section for setting in advance.
Fig. 3-19
Parameter description:
Quality of Service (QoS) Vlan Tag Configuration:
Used for setting up the QoS belongs to Vlan operation.
Port:
User can set up the port (1~24) respectively to let Vlan Tag QoS function
work on them. If you would like to set up all ports at a time, user is also
allowed to choose "All" in the selection list to simplify the procedure of
configuration.
Publication date: January, 2006
Revision A2
64