TP-Link TL-SG3424 User Manual page 79

logout
Syntax:
logout
Description:
When you enter this command via Telnet connection, you would logout the system
and disconnect. If you connect the system through direct serial port with RS-232
cable, you would logout the system and be back to the initial login prompt when you
run this command.
Argument:
None.
Possible value:
None.
Example:
GEL2-SW24# logout
restore default
Syntax:
restore default
Description:
When you use this function in CLI, the system will show you the information "Do you
want to restore the default IP address?(y/n)". If you choose Y or y, the IP address
will restore to default "192.168.223.100". If you choose N or n, the IP address will
keep the same one that you had saved before.
If restoring default successfully, the CLI would prompt if reboot immediately or not. If
you press Y or y, the system would reboot immediately; otherwise, it would be back
to the CLI system. After restoring default configuration, all the changes in the startup
configuration would be lost. After rebooting, the entire startup configuration would
reset to factory default.
Argument:
None.
Possible value:
None.
Example:
GEL2-SW24# restore default
Restoring ...
Restore Default Configuration Successfully
Press any key to reboot system.
149
User Manual
Publication date: January, 2006
Revision A2
User Manual
restore user
Syntax:
restore user
Description:
To restore the startup configuration as user defined configuration. If restoring default
successfully, the CLI would prompt if reboot immediately or not. If you press Y or y,
the system would reboot immediately; others would back to the CLI system. After
restoring user-defined configuration, all the changes in the startup configuration
would be lost. After rebooting, the entire startup configuration would replace as user
defined one.
Argument:
None.
Possible value:
None.
Example:
GEL2-SW24# restore user
Restoring ...
Restore User Configuration Successfully
Press any key to reboot system.
save start
Syntax:
save start
Description:
To save the current configuration as the start one. When you enter this command,
the CLI would save your current configuration into the non-volatile FLASH. If you
want the configuration still works after rebooting, save the configuration using the
command 'save stat'.
Argument:
None.
Possible value:
None.
Example:
GEL2-SW24# save start
Saving start...
Save Successfully
GEL2-SW24#
Publication date: January, 2006
Revision A2
150