Bravo-Brava i g |
12v
Steering
Steering gear
41.
Variable
ratio
rack-and-pinion
steering gear
Dismantling-refitting
1. undo the nuts shown and remove
the steering damper;
slacken the tie-rod locking nut then un
screw the tie-rod until you can remove it;
3. undo the clamps on the dust gaiter and lu
bricating seal, and remove the gaiter.
NOTE Check that there is no stiffness or ex
cessive play on the ball joint, other
wise it will need to be replaced.
NOTE
Thoroughly
check the gaiter
for
holes or tears, and if necessary re
place it.
■ M
Before fitting the last gaiter
(pinion
Y£K\
side), insert the specified quantity of
■■■■ grease.
Copyright Fiat Auto
7