Bravo-Brava
Gearbox and differential
Removing - refitting
21-27.
1. Remove the plastic wheelarch protection
on the gearbox by undoing the bolts and
retaining button shown in the figure. To
withdraw the protection, it is also neces
sary to disconnect the brake pad wear
sensor connector (repeat the procedure
on the other side).
2. Remove the nut securing the steering tie-
-rod end, then withdraw the latter from
the vertical link arm using the puller
1847038000 (repeat the procedure for
the other tie-rod end).
3. Remove the nuts securing the vertical link
(gearbox and timing side) to the damper.
4. Rotate the vertical link as appropriate so
as to withdraw the drive shaft from the
wheel hub (repeat the operation for the
other drive shaft).
Copyright Fiat Auto
25