Bravo igSi 2 < > v
Gearbox and differential
Removing-refitting
21-27.
P4A041B04
1. Rear attachment of gearbox support tool
1860873000.
2. Remove the engine mounting, gearbox side.
3. Manoeuvre the hydraulic jack as appropri
ate in order to disengage the gearbox from
the attachment studs and surrounding
parts. Gradually lower the jack and with
draw the gearbox.
Refitting
4. When fitting the engine mounting, gear
box side, to avoid creating stresses on the
sealing surfaces between the mounting
and the gearbox, resulting in deformation
and subsequent oil leak, closely follow the
bolt tightening sequence below:
- Tighten bolts (1) and (2) to a prelimi
nary torque di 0.5 daNm;
- Tighten bolts (3) and (4) to a prelimi
nary torque of 0.5 daNm, then tighten to
the specified torque;
- Tighten the bolts (1) and (2) to the
specified torque.
For the remaining refitting operations, re
verse the procedure described for removal.
Before fitting the bellhousing in the car,
check that the clutch release bearing is
positioned correctly on the gearbox main-
shaft.
v w
The oil level in the gearbox must be 9
Tjjyk mm below the oil filler plug hole.
Copyright Fiat Auto
57