Fiat Bravo Service Manual page 293

Bravo-Brava lg|
12v
Gearbox and differential
Drive shafts
21-27.
1. If interventions on the right drive shaft in­
volve dismantling the damping weight,
during reassembly refit the weight at the
distance specified in the figure.
2. Undo the clips securing the protective
gaiter on the constant velocity joint, wheel
side, then withdraw it from the side oppo­
site the drive shaft.
3. Clean the grease off the inside of the con­
stant velocity joint, and using tools
1847017001 and 1860889000 simulta­
neously on the circlip inside the joint, re­
move the joint from the drive shaft.
4. Check that the drive shaft is not deformed
or out of true, and that the seal contact
surface is not worn.
Copyright Fiat Auto 11