Konica Minolta bizhub C252 Network Scanner Operations page 154

4
7
Touch [Index] and touch the desired button.
– This specifies the characters used to index the destination.
– For destinations that are often used, specify [Main] at the same
time, and it will be easier to search.
– If the first character of the name is a letter, the first character is
automatically registered as the indexing character.
– The registration cannot be completed unless settings have been
specified for "Name" and "User Box Name".
8
Touch [OK], and then touch [OK] in the next screen that appears.
The box destination is registered.
!
Detail
To check the registered destination, touch the button for the destination,
and then touch [Check Setting].
To change the registered destination settings, touch the button for the
desired destination, and then touch [Edit].
To delete the registered destination, touch the button for the desired
destination, and then touch [Delete].
Note
To cancel changes to the setting, touch [Cancel].
To quit specifying the Utility mode setting, touch [Exit] in the sub display
area or press the [Utility/Counter] key. Otherwise, cancel the Utility mode
by touching [Close] in each screen until the screen for the Copy, Fax,
Scan or Box mode appears.
!
Detail
To specify a user box name, boxes must be registered in advance. Refer
to the User manual [Box Operations] for more details.
!
Detail
For the procedure to enter characters, refer to "Entering text" on
page 7-6.
4-24
Specifying settings from the control panel
bizhub C252