Setting Up The System; Local Connection - Konica Minolta bizhub C203 Operation Manual
Network scanner operations / fax operations / network fax operations
Hide thumbs
Also See for bizhub C203:
- Service manual (1028 pages) ,
- Copy operations (604 pages) ,
- User manual (534 pages)
Table of Contents
Advertisement
Fax Driver
11.1.3
Setting up the system
In order to use this printing system, it must first be set up.
Setup consists of connecting this machine to a computer and installing the fax driver onto the computer
being used.
!
Detail
This manual describes the setup method of network connection only for Port9100/IPP/IPPS that will be
installed by the installer, and LPR/Port9100 that will be installed by Add Printer Wizard printing.
For installation procedures via other network connections, refer to the User manual – Print Operations.
Network connection
1
Connect this machine to a computer.
2
Make sure the computer is connected to the network.
3
Specify the IP address of the machine to connect it to the network.
4
Depending on the connection method and protocol, change the network settings of this machine.
–
LPR: Enable LPD print on the LPD Setting screen.
–
Port9100: Enable the RAW port number (9100 at default), on the TCP/IP setting screen.
–
SMB: Specify "Print Setting" on the SMB Setting screen.
–
IPP/IPPS: Enable IPP print on the IPP Setting screen.
5
Install the fax driver.
–
Specify the network port of the fax driver according to the connection method and protocol.
Local connection
1
Connect this machine to a computer
2
Install the fax driver.
!
Detail
For details on connecting this machine to a computer, refer to the User manual – Print Operations.
To update an existing fax driver, delete the existing fax driver first. For details, refer to "Uninstalling the
fax driver" on page 11-16.
bizhub C353/C253/C203 (FE2)
11
11-5
Advertisement
Table of Contents
Troubleshooting
