Panasonic KX-TVS75 Installation Manual page 235

Parameter
Release for
Intercom
Paging
No-Answer
Time for
Intercom
Paging
Announcement
Repeat Cycle
Intercom
Paging Retry
Paging Code
for Group 1-8
Other Parameters - Fax Management
The VPS can be programmed to automatically transfer incoming fax calls to a fax extension.
A maximum of 2 fax extensions can be specified as the destination for the Automatic Fax
Transfer. If the main fax extension is not available to receive a fax, the VPS will transfer the
fax transmission to the alternate fax extension.
To select Fax Management, follow the menu path as shown:
System Administration Top Menu - 1 - 5 - 6 - 8
SYSTEM ADMINISTRATION
Value Range
(Default)
Up to 12 digits con- Specifies the intercom paging release code required by the
PBX. Up to 12 alphanumeric characters can be set using
sisting of 0-9, , #
the same letters and dial codes as specified above.
and special codes
(None)
1-30 sec When there is no answer, this parameter specifies the
(5) length of time (in seconds) the VPS must wait before
concluding Intercom Paging.
The VPS will return to the caller if the paged party does
not respond before this timer expires.
1-3 times Specifies the number of times the intercom page will be
(1) announced.
Example:
"There is a call for (mailbox owner's name)."
1-10 times Specifies the number of times paging will be retried when
(2) the paging destination is busy or if there is no answer.
Note: This setting applies when the subscriber has set only
"Intercom Paging" status to enable in Incomplete Call
Handling Status.
Up to 12 digits Specifies the intercom paging access code required by the
PBX.
consisting of 0-9, ,
# for each group
Note: The Intercom Paging Group Number available for
(none)
each Subscriber is determined on a COS-by-COS basis.
B6 SYSTEM ADMINISTRATION - SYSTEM PARAMETER SETTINGS
Table 67
Description/Function
235