Loading New Or Saved Data To The Vps (Load) - Panasonic KX-TVS75 Installation Manual

Note
"8. Company Greeting" is available for TVS200 only.
2.
Select item to be backed up, then Press RETURN. The size of the file will be displayed.
To start press 'RETURN'
3.
Press RETURN.
- - - - - - SAVE Start !!
4.
Perform a Standard File Transfer. Set the data terminal to the receiving (Answer) mode
(Xmodem) and specify the backup filename. The specified data will be transmitted to the
data terminal.
Note
The data terminal used must be equipped with communications software that supports
the Xmodem file transfer protocol. The command can be cancelled by Typing [\]
before entering the receiving mode. Once the receiving mode has been selected, use
the cancel command of the communication software being used. When you are
finished saving files, Type [ONLN] at the $ prompt. This will turn on the Call
Progression Mode of the VPS (calls will be accepted again).

7.2.8 Loading New or Saved Data to the VPS (LOAD)

This command is used to install new data or to restore the saved data to the VPS. The LOAD
command must be executed for each data file.
When performing this operation, always wait until the process completion indication appears
before proceeding.
1.
Type LOAD, then Press RETURN.
$ LOAD
Disk Data Load (PC -> VPS : Xmodem)
1: Program
2: Parameters
3: System Prompts
4. User Prompts-1
5. User Prompts-2
6. Custom Service Menu
7. Personal Greeting
8. Company Greeting
Select No.:
SYSTEM MAINTENANCE AND TROUBLESHOOTING
7.2 UTILITY COMMANDS
145