Circuit Condition Display (Lmon); Dtmf Information Display (Putd) - Panasonic KX-TVS75 Installation Manual

7.2.18 Circuit Condition Display (LMON)

This command is used to display the circuit condition every 1.5 s. To disable the display in the
VT100 mode, Type [\]. When in the ASCII mode, the circuit condition is only displayed once.
The command can be turned off by entering [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call Service"
"Outgoing Call Service"
"DSP Reset Processing"
"PITS connect Processing" : Processing PITS connect disposition
"Error/Not Exist"
$ LMON
CO No.:
10:
11:
12:

7.2.19 DTMF Information Display (PUTD)

This command is used to display the DTMF tones the VPS receives and sends.
In addition to the DTMF tones the following are displayed — the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting for this mode for all ports is "OFF."
SYSTEM MAINTENANCE AND TROUBLESHOOTING
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: DSP Card is not loaded
Status
1: Ready
2: Ready
3: Ready
4: Ready
5: Ready
6: Ready
7: Ready
8: Ready
9: Error/Not Exist
Error/Not Exist
Error/Not Exist
Error/Not Exist
7.2 UTILITY COMMANDS
151