Removing A Hard Disk Drive From The Slot Load Optical Bay - HP Z800 Workstation Maintenance And Service Manual

Removing a hard disk drive from the slot load optical bay

1.
2.
3.
4.
5.
6.
7.
114 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the airflow guide (see
Remove the expansion card support and any card cables that might interfere with slot load
assembly removal.
Disconnect the optical drive power cable from the chassis power cable, and the optical drive data
cable from the system board (see
Disconnect the slot load drive data cable from the system board connector as shown in the following
figure.
Figure 5-45 Disconnecting the data cable from the system board
Disconnect the chassis power cable from the slot load drive power connector as shown in the
following figure.
Figure 5-46 Disconnecting chassis power cable from hard disk drive connector
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing the slot load optical disk drive on page
76).
78).
79).
102).
ENWW