Installing An Optical Disk Drive In The Optical Drive Bay - HP Z800 Workstation Maintenance And Service Manual

Installing an optical disk drive in the optical drive bay

1.
2.
3.
4.
5.
ENWW
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the airflow guide (see
If you are adding an additional drive, remove the filler tray (see
on page 94).
NOTE: Unused optical bay power cables are stored in this tray.
Lift and hold the drive release latch at the green touch point
into the bay . When the front of the drive is near its final position, release the latch, but continue
2
to slide the drive inward until the latch closes and engages the drive.
TIP: An optical drive longer than 175 mm (but less than 206 mm) must be installed in the middle
or bottom bay.
Figure 5-26 Installing the optical disk drive
TIP: During installation the adjacent drive or filler may move slightly. You might have to slide and
align both devices to get the release latch to close and engage both devices.
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing and installing components
76).
78).
79).
Removing a filler tray
while sliding the optical disk drive
99