HP Z800 Workstation Maintenance And Service Manual page 118

5.
6.
106 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Insert the slot load assembly into the chassis optical cage until it reaches the release latch.
Pull the latch and slide the slot load assembly into the chassis, past the latch.
Release the latch and then slide the assembly further into the chassis until it snaps into place
as shown in the following figure.
NOTE: Install the slot load optical bay with the slot load drive at the top.
Figure 5-36 Installing the slot load assembly
Connect the chassis power cable to the optical disk drive power cable as shown in the following
figure.
Figure 5-37 Connecting chassis power cable to optical disk drive power cable
manuals search engine
2
ENWW