HP Z800 Workstation Maintenance And Service Manual page 115
Hide thumbs
Also See for Z800 Workstation:
- Maintenance and service manual (304 pages) ,
- Specification (73 pages) ,
- Hardware setup manual (54 pages)
Table of Contents
Advertisement
7.
8.
9.
ENWW
Downloaded from
www.Manualslib.com
If a hard disk drive is installed, disconnect its power and data cables.
Lift and hold the drive release latch at the green touch point , and then slide the slot load assembly
out of the chassis
as shown in the following figure.
2
TIP:
Push on the slot load assembly from the inside of the chassis.
Figure 5-31
Removing the slot load assembly
Disconnect the power/data cable from the slot load optical disk drive.
Figure 5-32
Disconnecting the power/data cable from the drive
manuals search engine
Removing and installing components 103
- Quick Links:
- System Board Architecture
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
