Installing Dual Sff Hard Drives In The Optical Drive Bay; Installing The Hard Drives - HP Z800 Workstation Maintenance And Service Manual

Installing dual SFF hard drives in the optical drive bay

This section describes how to install two small form factor (SFF) hard drives in the workstation optical
drive bay, and how to connect the hard drive cables.

Installing the hard drives

1.
2.
3.
4.
5.
6.
7.
8.
126 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the airflow guide (see
Remove the expansion card support (see
Remove the green rails from the bracket by squeezing the tabs and sliding the rails out of the
bracket.
Orient the drive with the connectors on the rear of the drive facing toward the tabs on the bracket
rails.
Gently open the rails as shown in the following figure.
Figure 5-67 Installing the drive in the rails
Lower the drive into the rails
the hard drive, and then snap the rails into place.
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the airflow guide on page
Removing the expansion card support on page
as shown above. Align the four pins on the rails with the holes in
2
76).
78).
79).
80).
ENWW