Removing A Hard Disk Drive From The Slot Load Optical Bay - HP Z800 - Workstation - 6 GB RAM Maintenance And Service Manual

Removing a hard disk drive from the slot load optical bay

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3. Remove the airflow guide (see
4. Remove the expansion card support and any card cables that might interfere with slot load
assembly removal.
5. Disconnect the optical drive power cable from the chassis power cable, and the optical drive data
cable from the system board (see
6. Disconnect the slot load drive data cable from the system board connector as shown in the following
figure.
Figure 5-45
7. Disconnect the chassis power cable from the slot load drive power connector as shown in the
following figure.
Figure 5-46
112 Chapter 5 Replacing components
Removing the airflow guide on page
Removing the slot load optical disk drive on page
Disconnecting the data cable from the system board
Disconnecting chassis power cable from hard disk drive connector
Predisassembly procedures on page
Removing the side access panel on page
74).
76).
77).
100).
ENWW