Installing The Airflow Guide; Expansion Card Support; Removing The Expansion Card Support - HP Z800 Workstation Maintenance And Service Manual

Installing the airflow guide

1.
2.
3.
4.

Expansion card support

To prevent card movement during shipping, an expansion card support is installed. This section
describes how to remove and install the expansion card support.

Removing the expansion card support

1.
2.
80 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Insert the airflow guide tabs into the rear chassis slots
clicks into place in the chassis
Figure 5-6 Installing the airflow guide
Reinstall all removed components and reconnect any cables that have been disconnected.
Disconnect power from the workstation (see
Remove the side access panel (see
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
, and then lower the airflow guide until it
as shown in the following figure.
2
Predisassembly procedures on page
Removing the side access panel on page
76).
78).
76).
78).
ENWW