HP Z800 Workstation Maintenance And Service Manual page 131

5.
6.
ENWW
Downloaded from www.Manualslib.com
Lift and hold the drive release latch at the green touch point
into the bay. When the front of the carrier is near its final position, release the latch, but continue
to slide the carrier inward until the latch closes and engages the carrier
NOTE: Install the slot load optical bay with the slot load drive at the top.
Figure 5-54 Installing the slot load assembly in the chassis
Connect the chassis power cable to the hard drive power connector as shown in the following
figure.
TIP: Place excess cabling in the slot load bay.
Figure 5-55 Connecting chassis power cable to hard drive connector
manuals search engine
while sliding the slot load carrier
.
2
Removing and installing components 119