Installing The Side Access Panel Sensor - HP Z800 Workstation Maintenance And Service Manual

4.
5.

Installing the side access panel sensor

To replace the side access panel sensor, reverse the removal steps.
NOTE:
supply sliding zone.
86 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Disconnect the sensor cable from the inline chassis cable as shown in the following figure
Figure 5-13 Removing the side access panel sensor
Slide the sensor back in its slot, push the sensor down, and then remove it from the chassis
The cable must be looped and stored in the cable clip provided to ensure it is not in the power
manuals search engine
.
.
2
ENWW