Removing The Hp Pocket Media Drive Bay Or Hard Disk Drive - HP CQ5110F - Presario - 3 GB RAM Upgrade And Service Manual

5 Connect the power and data cables to the back of the optical drive that you want to
add. Reconnect the sound cable, if present.
Parallel ATA drive
WARNING: If you are connecting a second Parallel ATA drive, make sure to
connect the data cable labeled Master to the primary hard disk drive, and the
data cable labeled Slave to the secondary hard disk drive. If the data cable is
not connected correctly, the computer is unable to locate the hard disk drive
and data may be lost.
6 Push the drive all the way in through the front of the chassis until it locks into place.
7 Insert the drive latch pin fully into the hole labeled (2).
8 Replace the front and side panels, and then close the computer. See "Opening and
Closing the Computer" on page 1.
Removing the HP Pocket Media Drive bay or hard
disk drive
1 Prepare the computer to be opened, and then remove the side and front panels. See
"Opening and Closing the Computer" on page 1.
2 Release the HP Pocket Media Drive bay or hard disk drive by removing the two screws
on the side of the drive. Then slide the drive partway out of the front of the chassis.
Serial ATA drive
Upgrading and Servicing Guide
11