Installing A Pci Card - HP Z800 Workstation Maintenance And Service Manual

Installing a PCI card

1.
2.
3.
4.
5.
154 Chapter 5 Replacing components
Downloaded from www.Manualslib.com
Disconnect power from the workstation (see
Remove the side access panel (see
Remove the expansion card support (see
Raise the rear retention clamp by lifting the metal bar or the green lever as shown in the following
figure .
Figure 5-98 Removing the slot cover
Lift the slot cover straight up to remove it from the chassis
TIP: Grasp the slot cover between two fingers—one from the inside of the chassis, and one from
the outside.
manuals search engine
Predisassembly procedures on page
Removing the side access panel on page
Removing the expansion card support on page
.
2
76).
78).
80).
ENWW