Sony HXC-100 Service Manual page 66

5. Remove the four screws and lift the TX-126
board.
6. Disconnect the coaxial cable from the con-
nector CN601 on the TX-126 board.
n
Be sure to hold the plug when disconnecting
the coaxial cable. Do not pull the cable.
7. Install a new TX-126 board by reversing the
steps above.
m
. Attach soft shields to the fi lter box at the
positions shown in the fi gure.
. Hold the plug of the coaxial cable, and
connect it perpendicularly to the connector.
Push the plug into the connector while turn-
ing it clockwise and counterclockwise
several times.
2-24
Hold the plug to remove.
Coaxial cable
TX-126 board
Soft shields
CN601
Soft shields
TX-126 board
Do not attempt to remove by
pulling the cable.
PSW3 x 6
PSW3 x 6
Filter box
Hold the plug to connect.
Connector
HXC-100/V1 (E)