2-8-14. SW-1404 Board
1. Remove the inside panel.
(Refer to Section 1-4.)
2. Remove the waterproof rubber from the
toggle switch.
3. Remove the screw to remove the SW-1404
board in the arrow direction.
4. Disconnect the harness from the connector
CN1 on the SW-1404 board.
5. Install a new SW-1404 board by reversing the
steps above.
2-8-15. SW-1405 Board
1. Remove the inside panel and open the outside
panel. (Refer to Section 1-4.)
2. Remove the front assembly.
(Refer to Section 2-1.)
3. Remove the CN-3070 board.
(Refer to Section 2-8-3.)
4. Remove the VR knob, RE knob, and front
switch cushion.
5. Disconnect the harness from the connector
CN2 on the SW-1405 board.
6. Remove the screw to remove the SW-1405
board in the arrow direction.
7. Install a new SW-1405 board by reversing the
steps above.
HXC-100/V1 (E)
CN2
PSW2 x 5
RE knob
VR knob
Front switch cushion
PSW2 x 5
Waterproof rubber
CN1
SW-1404 board
SW-1405 board
2-21