2-8-5. CN-3072 Board
1. Remove the inside panel.
(Refer to Section 1-4.)
2. Disconnect the fl exible card wire from the
connector CN5 on the SY-363 board.
3. Disconnect the harness from the connector
CN6 on the SY-363 board.
4. Open the connector (1) cap.
5. Remove the six screws and draw the intercom
panel.
6. Disconnect the harness from the connector
CN1 on the CN-3073 board.
7. Disconnect the harness from the connector
CN2 on the CN-3072 board.
8. Remove the two screws to remove the
CN-3072 board.
9. Install a new CN-3072 board by reversing the
steps above.
2-16
SY-363 board
CN5
CN6
CN-3072 board
CN2
Harness
Intercom panel
CN1
Connector (1) cap
BVTP 3 x 12
M2 x 5
M2 x 5
BVTP 3 x 12
HXC-100/V1 (E)