Board - Sony HXC-100 Service Manual

2-8-8. FL-348 Board
1. Open the outside panel.
(Refer to Section 1-4.)
2. Remove the fi ve screws to detach the shield
case cover and insulation sheet.
3. Disconnect the harnesses from the connectors
CN1 and CN3 on the FL-348 board.
4. Remove the two screws and lift the FL-348

board.

5. Disconnect the coaxial cable from the con-
nector CN2 on the FL-348 board.
n
Be sure to hold the plug when disconnecting
the coaxial cable. Do not pull the cable.
6. Install a new FL-348 board by reversing the
steps above.
n
Hold the plug of the coaxial cable, and con-
nect it perpendicularly to the connector.
Push the plug into the connector while turn-
ing it clockwise and counterclockwise several
times.
2-18
PSW 3 x 6
Shield case cover
Insulation sheet
CN3
FL-348 board
Hold the plug to remove.
OK
Hold the plug to connect.
Connector
FL-348 board
CN1
PSW 3 x 6
CN2
Coaxial cable
Do not attempt to remove by
NG
pulling the cable.
HXC-100/V1 (E)