Board - Sony HXC-100 Service Manual

2-8-6. DPR-298 Board
1. Open the outside panel.
(Refer to Section 1-4.)
2. Remove the CD board assembly.
(Refer to Section 2-8-1.)
3. Disconnect the fl exible card wire from the
connector CN1 on the DPR-298 board.
n
Be careful not to bend the fl exible card wire.
This shortens the wire life.
4. Disconnect the coaxial cable from the con-
nector CN801 on the DPR-298 board.
n
Be sure to hold the plug when disconnecting
the coaxial cable. Do not pull the cable.
5. Remove the four screws to remove the
DPR-298 board.
6. Install a new DPR-298 board by reversing the
steps above.
n
Hold the plug of the coaxial cable, and con-
nect it perpendicularly to the connector.
Push the plug into the connector while turn-
ing it clockwise and counterclockwise several
times.
2-8-7. ENC-112 Board
For how to replace the ENC-112 board, refer to
"Section 2-8-1 CD-61 Board".
HXC-100/V1 (E)
CN801
PSW 3 x 6
Hold the plug to remove.
OK
Hold the plug to connect.
Connector
DPR-298 board
PSW 3 x 6
CN1
Coaxial cable
Do not attempt to remove
NG
by pulling the cable.
2-17