Sw-1406/A Board; Sw-1407 Board; Board - Sony HXC-100 Service Manual

2-8-16. SW-1406/A Board

1. Remove the inside panel.
(Refer to Section 1-4.)
2. Remove the intercom panel.
(Refer to Section 2-8-5.)
3. Remove the CN-3072 board.
(Refer to Section 2-8-5.)
4. Remove the ENCODER knob.
5. Remove the four screws to remove the
SW-1406/A board.
6. Disconnect the fl exible card wire from the
connector CN1 on the SW-1406/A board.
n
Be careful not to bend the fl exible card wire.
This shortens the wire life.
7. Remove the following components from the
SW-1406/A board.
. INCOM waterproof sheet
. Earth plate
. Switch cap
. Waterproof rubber
8. Install a new SW-1406/A board by reversing
the steps above.

2-8-17. SW-1407 Board

1. Remove the inside panel.
(Refer to Section 1-4.)
2. Detach the waterproof cap from the toggle
switch.
3. Remove the screw and draw the SW-1407

board.

4. Disconnect the harness from the connector
CN1 on the SW-1407 board.
5. Install a new SW-1407 board by reversing the
steps above.
2-22
SW-1406/A board
PSW2 x 5
CN1
Flexible card wire
Switch cap
Waterproof rubber
INCOM waterproof sheet
SW-1407 board
Earth plate
ENCODER knob
CN1
PSW2 x 5
Waterproof cap
HXC-100/V1 (E)