Board - Sony HXC-100 Service Manual

2-2-3. PA-353 Board
Replacement
The PA-353 board is not a spare part.
When replacing the PA-353 board, replace the
CCD unit with the PA-353 board contained.
Removal
This unit uses three PA-353 boards (for channels
R, G, and B). The following describes the proce-
dure of removing the PA-353 board of channel G
as an example.
1. Remove the inside panel and open the outside
panel. (Refer to Section 1-4.)
2. Remove the CCD unit. (Refer to Section 2-1.)
3. Remove the DR-632 board.
(Refer to Section 2-2-1.)
4. Remove the TG-265 board.
(Refer to Section 2-2-4.)
5. Disconnect the fl exible card wire from the
connector CN1 on the PA-353 board (channel
G).
n
Be careful not to bend the fl exible card wire.
This shortens the wire life.
6. Remove the four screws to detach the OHB
bracket.
7. Unsolder the pins of the image sensor to
remove the PA-353 board (channel G).
Installation
1. Install a new PA-353 board (channel G) by
reversing the steps of removal.
2-4
PA-353 board (channel B)
Image sensor
PA-353 board (channel R)
OHB bracket
PSW 2 x 5
PSW 2 x 5
CN1
Flexible
card wire
PA-353 board (channel G)
HXC-100/V1 (E)