IBM Midrange System DS4000 Series Hardware Manual page 510

Remote Mirror commands
Table 8-10 lists these commands.
Table 8-10 Remote Mirror commands
Command
activate storageSubsystem
feature=remoteMirror
create remoteMirror
deactivate
storageSubsystem
feature=remoteMirror
diagnose remoteMirror
recreate storageSubsystem
mirrorRepository
remove remoteMirror
resume remoteMirror
set remoteMirror
show remoteMirror
candidates
show remoteMirror
localLogicalDrive
synchronizationProgress
start remoteMirror
primary synchronize
suspend remoteMirror
492
IBM Midrange System Storage Hardware Guide
Description
This command creates the mirror repository logical drive and
activates the Remote Mirror feature.
This command creates both the primary and secondary logical drives
for a Remote Mirror.
This command deactivates the Remote Mirror feature and tears down
the mirror repository logical drive.
This command tests the connection between the specified primary
logical drives and mirror logical drives on a storage subsystem with
the Remote Mirror feature installed.
This command creates a new Remote Mirror repository logical drive
using the parameters defined for a previous Remote Mirror repository
logical drive.
This command removes the mirror relationship between the primary
logical drive and secondary logical drive.
This command resumes a suspended Remote Mirror operation.
This command defines the properties for a Remote Mirror pair.
This command returns information about the candidate logical drives
on the remote storage subsystem that you can use as secondary
logical drives for a primary logical drive.
This command returns the progress of data synchronization between
the primary logical drive and secondary logical drive in a Remote
Mirror.
This command starts Remote Mirror synchronization.
This command suspends a Remote Mirror operation.