Enclosure Commands - IBM Midrange System DS4000 Series Hardware Manual

Enclosure commands

Table 8-5 lists these commands.
Table 8-5 Enclosure commands
Command
download enclosure
firmware
set enclosure id
set enclosure
serviceAllowedIndicator
start enclosure locate
stop enclosure locate
Array commands
Table 8-6 lists these commands.
Table 8-6 Array commands
Command
delete array
revive array
set array
show array
start array
defragment
488
IBM Midrange System Storage Hardware Guide
Description
This command downloads ESM firmware.
This command sets the ID of a DS4800 82A/84A storage subsystem.
The range of valid IDs is from 80 through 99. This range avoids conflicts
with existing drive module IDs used for attached expansion enclosures.
This command turns on or turns off the Service Action Allowed indicator
light on the power-fan canister or interconnect module in a DS4800
82A/84A subsystem.
This command locates an enclosure by turning on the indicator lights.
This command turns off the enclosure indicator lights that were turned
on by the start enclosure locate command.
Description
This command deletes an entire array and its associated logical drives.
There can be potential storage subsystem configuration damage.
This command forces the specified array and associated failed physical
disks to the Optimal state.
This command defines the properties for an array.
This command returns the following information about an array:
Status (online or offline)
Drive type (Fibre or SATA)
Enclosure loss protection (yes or no)
Current owner (controller slot A or slot B)
Associated logical drives and free capacity
Associated physical disks (drives)
This command starts a defragment operation on the specified array.