System View - Bosch ICP-AMAX4-P1 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
Reset to Factory Default Settings
The factory default can be reset with the 'resetting to factory default' pads on the main board
of the AMAX panel.
1.
2.
3.
4.
5.
6.
Notice!
If the default pads are short-circuited for over 10 seconds after power-up, the AMAX panel
will discard resetting to factory default.
7.5.2

System View

Fault Analysis
AMAX panel can display eight categories of 41 kinds of system failure.
Bosch Sicherheitssysteme GmbH
Disconnect the AC power supply and backup battery to the AMAX panel.
Short-circuit the 'resetting to factory default' pads.
These set of pads are located at the top on the printed circuit board of the AMAX panel.
Powering up is done when the bonding pads are short-circuited.
Quick flash of the red LED indicator on the printed circuit board of the AMAX panel
indicates that the factory default will be reset.
All programming parameters are reset to factory default immediately after releasing the
short - circuited bonding pads.
Installation Guide
Settings | en 63
2014.4 | 01 | F.01U.267.112