Status Indicator; Dx3010; General; Address Setting - Bosch ICP-AMAX4-P1 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
Power Supply
AMAX Panel
AMAX Panel (DX2010 Out not
used)
External Power Supply
Table 5.6: Lengths of cable for DX2010
AMAX 4000
Figure 5.4: Connecting DX2010 to the AMAX Panel
5.3.4

Status Indicator

LED Condition
On
Flash (once per second)
Off
5.4

DX3010

5.4.1

General

The AMAX panel supports DX3010 output expansion modules. Each module supports eight
fully programmable relay outputs. For more information about installation, see DX3010
Installation Guide.
See also
–
5.4.2

Address Setting

Each DX3010 module connected to the AMAX panel must have its own data bus address.
Bosch Sicherheitssysteme GmbH
AMAX 2100 / 3000
Module Installation, page 23
Optional Modules and Peripheral Devices | en
Wire diameter of 0.8mm
30m
305m
305m
DX2010
Denotation
Trouble Condtion:
– Grounding Conductor is not connected or there is a
communication failure between the module and the AMAX
panel.
– No zones distributed
– Module address setting error
Normal Operation
Power failure
Installation Guide
Wire diameter of 1.2mm
76m
610m
610m
DX2010
_
+
12V
2014.4 | 01 | F.01U.267.112
15