Image Is Blurred (Shifted Transferring) - Kyocera ECOSYS M3040dn Service Manual

(16) mage is blurred (Shifted transferring).
Print example
Defective part
Paper
1
Fuser unit
2
Paper conveying
motor
3
Paper conveying
guide
4
1. The paper used does not conform to the requirement.
2. Imbalanced fuser unit pressures.
Check description
1. Check that the type of the
paper used falls within the
range of specifications.
2. Check the settings of the
type and weight of the paper.
1. Check the fuser pressure
balance.
2. Check if the fuser paper-
inserting guide is deformed.
Check to see if the driving mech-
anism for paper conveying is
operative without a hinderance.
The paper conveying guide is
deformed.
Cause of trouble
1. If the type of the paper being used falls
outside the requirements, replace and use
a suitable type of paper.
2. If the settings made for the paper being
used is inadequate, configure the settings
according to the paper being used.
1. If the pressures at the front and rear are
unbalanced, replace the fuser unit.
(see page 1-5-44)
2. If the fuser unit is deformed, replace.
(see page 1-5-44)
If the drive does not operate normally, apply
grease.
If the paper conveying guide is deformed,
replace the paper conveying guide.
1-4-90
2NM/2NX/2NY/2NZ/2P0/2P6
Corrective Action