Sheet Through Actuator Removal - Lexmark X850e Service Manual

Sheet through actuator removal

1.
Open the ADF left cover assembly.
2.
Remove the ADF left cover media guide. See
3.
Remove the ADF feed/pick roll assembly. See
4.
Remove the screw from the green ground wire (A).
5.
Remove the screw securing the grounding plate (B).
6.
Remove the grounding plate (B).
7.
Remove the two screws securing the harness guide (C).
8.
Remove the harness guide (C).
9.
Remove the one screw securing the pick roll position motor assembly (D).
10.
Remove the pick roll position motor assembly (D).
11.
Remove the one screw securing the rear bracket (E).
Warning: Shims may be present under the rear bracket (E) and may possibly fall out. Note the locations of any
shims.
12.
Remove the rear bracket (E).
13.
Gently pry the sheet through actuator (F) out of the ADF left cover assembly.
"ADF left cover media guide removal" on page
"ADF feed/pick roll assembly removal" on page
7500-XXX
4-181.
4-178.
4-175
Repair information