Dual Drive Motor Assembly Removal - Lexmark X850e Service Manual

Dual drive motor assembly removal

1.
Remove the rear RIP card cover. See
2.
Remove the rear motor cover. See
3.
Open the printer left door assembly.
4.
Remove the PC cartridge.
5.
Remove the exit 1 drive belt. See
6.
Disconnect the two harness connectors from the dual drive motor assembly (A).
Connector
Connector
7.
Remove the four screws securing the dual drive motor assembly (A) to the printer.
8.
Remove the dual drive motor assembly (A).
Warning: Depress the spring loaded gear (C) while removing the dual drive motor assembly (A) to prevent
damage.
Warning: Before reinstalling, depress the spring loaded gear (C) while replacing the dual drive motor assembly
(A) to prevent damage.
"Rear RIP card cover removal" on page
"Rear motor cover removal" on page
"Exit 1 drive belt removal" on page
A
4-13.
4-11.
4-112.
C
Rear
Repair information
7500-XXX
4-113